Reactive power and harmonic compensation: A case study for the coal-mining industry
DOI:
https://doi.org/10.17159/2413-3051/2019/v30i1a2473Abstract
This study reports on a case study in Grootegeluk Mine: Exxaro Coal, Lephalale, South Africa, in terms of power factor correction (PFC), load flow, harmonic frequency scans and harmonic voltage distortion analyses. The DIgSilent PowerFactory software was used for network simulations. Harmonic and reactive power compensation techniques were compared in terms of filter type evolution and technology advancement, with the use of simple trade-off criteria such as cost-effectiveness versus performance. It was found that both passive and hybrid filters were more favourable and could effectively compensate all voltage and current harmonics and reactive power for large nonlinear loads. The installation of switched PFC filter banks tuned at the fifth harmonic order accommodates future network growth and this solution can be rolled out to any mining industry as a benchmark to lower energy cost and maximise savings achievable on the electricity bill.
Downloads
References
Acha, E., Agelidis, V., Anaya, O., and Miller, T. J. E. 2002. Power electronic control in electric systems. Oxford: Newness Power Engineering series.
Akagi, H., Watanabe, E. H., and Aredes, M. 2007. Instantaneous power theory and applications to power conditioning. New Jersey, USA: John Wiley & Sons.
Fuchs, E. F., and Mausoum, M. A. S. 2008. Power quality in power systems and electrical machines. London, UK: Int. Journal of Academic Press.
Obulesu, Y. P., Reddy, M. V., and Kusumalatha, Y. 2014. A %THD analysis of industrial power distri-bution systems with active power filter case studies. Int. Journal of Electrical Power and Energy Systems, 60, 107–120.
Rahmani, S., Hamadi, A., Al-Haddad, K., and Des-saint, L. A. 2014. A combination of shunt hybrid power filter and thyristor-controlled reactor for power quality. IEEE Trans. Ind. Electron., 61 (5), 2152–2164.
Hu, H., Shi, W., Lu, Y. and Xing, Y. 2012. Design considerations for DSP-controlled 400 Hz shunt ac-tive power filter in an aircraft power system. IEEE Trans. Ind. Electron., 59 (9), 3624–3634.
Du, X., Zhou, L., Lu, H., and Tai, H. M. 2012. DC link active power filter for three-phase diode rectifi-er. IEEE Trans. Ind. Electron., 59 (3), 1430–1442.
Gupta, N., Singh, S. P., and Bansal, R.C. 2012. A digital signal processor-based performance evalua-tion of three-phase four-wire shunt active filter for harmonic elimination, reactive power compensa-tion, and balancing of non-linear loads under non-ideal mains voltages. Electric Power Components and Systems, 40 (10), 1119–1148.
Angulo, M., Ruiz-Caballero, D.A., Lago, J., Heldwein, M. L., and Mussa, S. A. 2013. Active power filter control strategy with implicit closed loop current control and resonant controller. IEEE Trans. Ind. Electron., 60 (7), 2721–2730.
Singh, B., Chandra, A., and Al-Haddad, K. 1999. A review of active filters for power quality improve-ment. IEEE Trans. Ind. Electron., 46 (5), 960–971.
Lam, C. S., Choi, W. H., Wong, M. C., and Han, Y. D. 2012. Adaptive dc-link voltage-controlled hybrid active power filters for reactive power compensa-tion. IEEE Trans. Power Electron., 27 (4), 1758–1772.
Hamadi, A., Rahmani, S., and Al-Haddad, K. 2013. Digital control of hybrid power filter adopting non-linear control approach. IEEE Trans. Ind. Informat., 9 (4), 2092–2104.
Bhattacharya, A., Chakraborty, C., and Bhattachar-ya, S. 2012. Parallel connected shunt hybrid active power filters operating at different switching fre-quencies for improved performance. IEEE Trans. Ind. Electron., 59 (11), 4007–4019.
Batarseh, I., and Wei, H. 2001. Power factor correc-tion circuits. Florida, USA: Int. Journal of Inc., 517–541.
Emanuel, A. E., Orr, J. A., Cyganski, D., and Gula-chenski, E. M. (1993). A survey of harmonic voltag-es and currents at the customer’s bus. IEEE Trans. Power Delivery, 8 (1), 411–421.
Peng, F. Z. 2001. Harmonic sources and filtering approaches. IEEE Ind. Appl. Mag., 7 (4), 18–25.
Moran, L., Mahomar, J., and Dixon, J. 2002. Se-lecting the best point of connection for shunt active filters in multi-bus power distribution systems. in 37th IAS IEEE Proc. Industry Applications Annual Meeting, 1703–1709.
Al-Naseem O. A., and Adi, A. K. 2010. Impact of power factor correction on the electrical distribution network of Kuwait – a case study. Power and Elec. Engineering, 2 (1), 173–176.
Zaveri, N., and Chudasama, A. 2012. Control strat-egies for harmonic mitigation and power factor cor-rection using shunt active filter under various source voltage conditions. Int. Journal of Electrical Power and Energy Systems, 42, 661–671.
Subjak, J. S., and Mcquilkin, J. S. 1990. Harmon-ics-causes, effects, measurements, analysis: an up-date. IEEE Trans. Ind. Appl., 26 (6), 1034–1042.
IEEE Inc., 1993. IEEE recommended practices and requirements for harmonic control in electrical power systems. (IEEE Std. 519-1992), ANSI/IEEE Inc.
Batarseh, I. 2004. Power electronic circuits. Florida, USA: John Wiley & Sons Inc.
El, M. A., Samir, H., Ezz, A., Dalal, E. A., Helmi, H., and Ibrahim, M. T. 2007. The impact of capacitor bank installation on the performance of distribution systems – a case study. in Proc. 19th International Conference on Electricity Distribution, 1–4.
Hamadi, A., Rahmani, S., and Al-Haddad, K. 2010. A hybrid passive filter configuration for VAR control and harmonic compensation. IEEE Trans. Ind. Elec-tron., 57 (7), 2419–2434.
Flores, P., Dixon, J., Ortuzar, M., Carmi, R., Barri-uso, P., and Moran, L. 2009. Static VAR compensa-tor and active power filter with power injection ca-pability using 27-level inverters and photovoltaic cells. IEEE Trans. Ind. Electron., 56 (1), 130–138.
Junyi, L., Zanchetta, P., Degano, M., and Lavopa, E. 2012. Control design and implementation for high performance shunt active filters in aircraft power grids. IEEE Trans. Ind. Electron., 59 (9), 3604–3613.
Tang, Y., Loh, P.C., Wang, P., Choo, F. H., Gao, F. and Blaabjerg, F. 2012. Generalized design of high performance shunt active power filter with output LC filter. IEEE Trans. Ind. Electron., 59 (3), 1443–1452.
Milanés-Montero, M. I., Romero-Cadaval, E., and Barrero-González, F. 2011. Hybrid multiconverter conditioner topology for high-power applications. IEEE Trans. Ind. Electron., 58 (6), 2283–2292.
Akagi, H. 2005. Active harmonic filters. In Proc. IEEE, 93 (12), 2128–2141.
Akagi, H. 1996. New trends in active filters for pow-er conditioning. IEEE Trans. Ind. Applic., 32 (6), 1312–1322.
Antunes, C. H., Pires, D. F., Barrico, C., Gomes, A., and Martins, A. 2008. A multi-objective evolution-ary algorithm for reactive power compensation in distribution networks. Applied Energy, 86 (8), 977–984.
Miller, T. J. E. 1982. Reactive power control in elec-tric systems. USA: John Wiley & Sons Inc.
Caramia, P., Carpinelli, G., Gagliardi, F., and Verde, P. 1994. Analysis and design of a combined system of shunt passive and active filters. Int. Trans. Electri-cal Energy Systems, 4 (2), 155–162.
Capasso, A., Lamedica, R., Manigrasso, R., Sani, G., Superti Furga, G., and Tironi, E. 1992. Reference power network for the harmonic propagation anal-ysis. Int. Trans. Electrical Energy Systems, 2 (3), 167–178.
Downloads
Published
Issue
Section
License
Copyright (c) 2019 F. Roos; R.C. Bansal
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.
.png){kind=spacer}